a nitrous purge the new pipe is needed in this installation. buy a new brake hose from spare part shops. at the end of the brake hose was raised so that they can be connected with nitrous purge solenoid.

enter the aluminum ring obtained from the purchase of pipe into the purge nitrous purge

 

 

 

 

 

 

use of nitrous hose bending when bending the pipe so neat purge.

This is a picture of solenoid gas, nitrous solenoid and solenoid purge (purge solenoid is located on the tip of the right), right next to the ABS unit. therefore a new purge hose should surround it.

enter the pipe bending pipe into the purge nitrous from brand NOS. mark the sections to be bent with a pencil so that no wrong.

This enables the pipe bending to pass the ABS unit

This is a picture tube that is connected with nitrous purge solenoid

make two to round the bend for vertically and horizontally along the front bonnet

place amid so as not to interfere with the operator of windshield cleaner

after some bending, install temporary lights purge to check his position. mark the purge lamp position in the pipe. after that you can release the light of this purge again.

use a hacksaw to cut the pipe unused

the right size to make a neat job.

use cable ties to bind the pipe with the brake hose. This can avoid moving during the purge pipe activate or car running.

ZEX products provide an extra cable for multiple devices (such as a socket), this makes the job easier

after removing the bottom of the dashboard, we have access to connect the module to the solenoid and switch. white wire is directed into seleniod while the red wire to the ignition and switch

while the power cable and ground wires connected to light with the help of solder purge after that part that has been soldered coated with insulation. form a cable such as the webbing before joined a purge solenoid. ZEX not recommend to remove the resistor, because it can cause damage to the LED

insert the cable into the cable cover purge lamp to make it more secure and neat. tied with cable ties between the cover of the cable with the pipe purge for better results.

now is the whole picture after the cable cover tied with a purge pipe using cable ties.

cut the rest of the cable ties that were not used to appear more presentable.

black wire from the lamp purge soldered to the negative part of the purge solenoid, while the red wire connected to the positive. after grafting finished wrap with insulation. now installing nitrous purge is complete

 

 

 

 

here's the view lamp ZEX nitrous purge after the installation is complete. if you want a video clip how this installation can visit www.ZEX.com. good luck.